DINOSAUR ELECTRONICS HOME PAGE
IGNITOR BOARDS REPLACEMENTS for ONAN® OTHER PRODUCTS
REPLACEMENTS for DOMETIC® REPLACEMENT EYEBROWS COMPANY INFORMATION
REPLACEMENTS for NORCOLD® BOARD TESTERS WARRANTY INFO
CUSTOMER SERVICE


FAN 50 PLUS


***Has been discontinued and replaced by the Fan 50 Plus Pins
and is functionally the same as the Fan 50 Plus. It has an added 6-pin header connector as well as the original edge connector.***

The FAN 50 Plus is designed to replace the new Suburban® # 232613 board and the Atwood® / HydroFlame®
# 37857 board as well as the Dinosaur Fan Control boards which have been available since the middle of 1994.

The basic purpose of a Fan Control Ignitor board is to shut the fan motor off if the board fails to sense a flame after
the third ignition try. Thus, battery drain is reduced and the needless blowing of cold air is eliminated.

The FAN 50 Plus, after shutting the fan motor off, will wait for 1 hour and repeat the whole sequence again before
permanent shut down.

For 12 VDC Furnaces ONLY!

The "Fan Control" feature MUST BE USED for proper operation of this board.

*Jumper selectable operation
*12 VDC operation
*Works in 12 VDC furnaces*
*Microcontrolled
*3.35" x 4.25"
*Diagnostic LED
*Instructions
*Three year warranty
*See our reference chart



*Note: Fan control boards should not be used in DuoTherm® 900 series furnaces that have the thermostat in
the ground circuit. DuoTherm® furnaces can be rewired to move the thermostat from the ground side of the circuit
to the positive side of the circuit so that the Fan control features of the Fan control or FAN 50 Plus board can be
used. Click here for instructions on how to do this in Adobe acrobat format.

Propane is an explosive gas!
Ignitor boards should be installed by trained service technicians.